cinetto B-moved PS40.3 Montageanleitung Seite 81

and operate the motor until the door reaches its open position.
In the event that the opening of a door is obstructed by another previously opened door, both doors will move simultaneously to
free the opening.
4.2 Door closing
The door closing command can be given by slightly pushing on the door or by using the remote control.
Push the door a few millimetres in its closing direction and the system will automatically detect the displacement and operate the
motor until the door reaches its closed position.
Alternatively, press the button on the radio control corresponding to the door to be closed and the system will receive the signal
and operate the motor until the door reaches its closed position.
4.3 Close all doors with a single command
To close all open or partially open cabinet doors, long press (3 seconds) one of the active remote control buttons for the confi gu-
ration in use. The system will automatically bring all doors to their closed positions.
5. Maintenance and care
5.1 General indications
In order to guarantee safety, the control unit must be disconnected from the power supply before any maintenance
operation on the system.
5.2 'B-Moved' system exterior cleaning
For external cleaning of the 'B-Moved' system and aluminium tracks, a dry cloth or, alternatively, compressed air should be used.
5.3 'B-Moved' system interior cleaning
Internal cleaning of the system must only be performed by qualifi ed personnel. The system is designed to work even if dust is
deposited inside. However, the removal of debris or foreign material from inside the system may be performed by using a jet of
compressed air.
It is prohibited to dismantle the movement system. Any action to do so shall free the company Cinetto F.lli S.r.l. from any
liability for consequential direct or indirect damage.
5.4 'B-Moved' system maintenance
The mechanical parts that make up the system are designed and built to work dry. Do not use greases, lubricating sprays or any
chemical products on the electrical or mechanical parts. Use of such products will damage the system.
5.5 Replacing the remote control battery
In the event that the remote control needs replacing:
• Replace the battery with an equivalent 'CR2032' type 3V battery. Inserting batteries other than those indicated may cause
irreversible damage to the remote control;
• Remove the screw on the back of the remote control and open the plastic body, taking care not to damage internal compo-
nents. Remove the old battery from its lodging and replace with the new battery, paying attention to its polarity.
• Close the remote control and check its functionality.
If necessary, repeat the procedure to pair the remote control as indicated in Section 3.4.
81