cinetto B-moved PS40.3 Montageanleitung Seite 5

SAFETY INSTRUCTIONS
Safety guidelines of "B-MOVED" system
Intended use
"B-Moved" control system by Cinetto is exclusively intended to move sliding doors for wardrobes or for walk-in clo-
sets. The maximum weight limit of each door, unless otherwise noted, is specifi ed on the technical datasheet of each
compatible sliding system by Cinetto. The system must be positioned at an inaccessible height for the user during the
normal use.
System restrictions
Stowing or placing or mounting any kind of material on the top of the furniture, except for the sliding system and B-MOVED sy-
stem itself, is strictly forbidden. Failure to respect this indication can irreversibly damage the system and determine a dangerous
condition for the user.
Use environment of the system
B-Moved system is designed, realized and tested for domestic use, in accordance with DIN 60335. The system is realized with
all the safety equipment in accordance with DIN 60335. Keep the system at a use temperature compatible with domestic environ-
ment, free from interfering material and protected against impact.
Risk evaluation activity during the project design
Risk of injury caused by automated door movement
Despite the risk of crushing and shearing, injuries are prevented, during normal operation, by the optimization of para-
meters based on the safety and functionality of the system. There are indirect variables that can compromise the smooth
operation of the hardware and the software, as examined in case of failure of electronic components. In order to bring
the risk caused by the automatic handling of the doors to an acceptable level, the system was designed by combining
electromechanical components capable of exerting, when out of control, a maximum force of 200N measured in the operating
range of the end user. This value was considered acceptable because it does not represent a real risk of injury to people or pets.
The system put out of control can generate that force just in the case, considered rare, in which failure occurs during the motion of
a door and only until it reaches the mechanical stop. After the fault, the system blocks and goes out of service.
"B-Moved" system cannot be used with products out of the ones
allowed by the producer.
In any case the producer is not responsible for improper installa-
tion and use.
The system must be used only with the control unit supplied by the
producer.
The system must be used only with the power unit supplied with the
control unit.
The transmission system must be positioned at an inaccessible hei-
ght for the user during the normal use, keep the minimum safety
high of 2.5 mt.
During "B-Moved" design activity have been evaluated severe and low risks. To ensure the
user's safety have been applied preventive actions. Due to this, following the use and installa-
tion instructions is mandatory.
The following risks have been evaluated: shear and collision risk; environmental agents' al-
teration and impact during transport; alteration after impact during installation and mainte-
nance; unintentional emission, transmission and reception of electromagnetic signals; electric
shock risk; wear risk; overheating and fi re risk; malfunctioning after wrong installation risk.
5