Eu Declaration Of Conformity; En Safety Information - Atlas Copco Focus 60 Sicherheitshinweise

Focus 60/61
Technical data
Product data
Voltage 100-240 V a.c.
Power 25 W
Declarations
Notice
Many events in the operating environment may af-
fect the tightening process and shall require a vali-
dation of results. In compliance with applicable
standards and/or regulations, we hereby require
you to check the installed torque after any event
that can influence the tightening result. Examples
of such events include but are not limited to:
• initial installation of the tooling system
• change of part batch, bolt, screw batch, tool,
software, configuration or environment
• change of air- or electrical connections
• change in line ergonomics, process, quality
procedures or practices
• changing of operator
• any other change that influences the result of
the tightening process
The check should:
• Ensure that the joint conditions have not
changed due to events of influence.
• Be done after initial installation, maintenance
or repair of the equipment.
• Occur at least once per shift or at another suit-
able frequency.

EU DECLARATION OF CONFORMITY

We, Saltus Industrial Technique GmbH - Part
of the Atlas Copco Group, Schaberger Str. 49-53,
42659 Solingen, Germany, declare under our sole
responsibility that the product (with name, type
and serial number, see front page) is in conformity
with the following Directive(s):
2014/30/EU EMC, 2011/65/EC ROHS, 2014/53/
EU R&TTE, 2014/35/EU LVD
Harmonised standards applied:
ETSI EN 301489-3 v1.6.1 part 3, EN
61000-3-2:2014, EN 61000-3-3:2013
© Atlas Copco Industrial Technique AB - 9834 4137 00
Technical file available from:
Quality Manager, Saltus Industrial Technique
GmbH, Schaberger Str. 49-53, 42659 Solingen,
Germany
Solingen, 17 February 2016
Lars Eklöf, product quality manager
Signature of issuer
Conformity to North American
standards
WEEE
Information concerning Waste of Electrical and
Electronic Equipment (WEEE):
This product and its information, meets the re-
quirements of the WEEE Directive (2012/19/EU),
and must be handled in compliance with the direc-
tive.
The product is marked with this symbol:
Products with the symbol of a crossed out wheelie
bin with a single black line underneath, indicates
that parts within the product must be handled in
compliance with the WEEE Directive. The entire
product, or the WEEE parts, can be sent to your
"Customer Centre" for handling.
Safety Information
Listed
Conforms to UL
61010-1
Certified to CSA C22.2
No. 61010-1
3