GEZE TS 5000 R BG Montageanleitung Seite 17

TS 5000 R BG
Stow away loose cable in the cable protection and free area (7.).
X
X
Secure exposed cable with the cable protection film (8.).
X
X
CAUTION!
Check free upward movement of the rocker!
X
X
If necessary, the holding force can be adjusted (9.). According to EN 1155, the release torque should
amount to 40 Nm - 120 Nm for a door with 90° hold- open angle.
7.4 Mounting cover panel
CAUTION!
Do not pinch cable.
X
X
Clip on cover panel.
X
X
Fig.: 7.4.1
7.5 First Operation and Function Test
Remove the protective cap (if not already done).
X
X
Switch on power.
X
X
à Operation display GREEN lights up and electrical hold-open device is powered.
Lock door leaf in electrical hold-open device.
X
X
Operate reset button on the smoke switch.
X
X
à Indicator light glows YELLOW for about 4 seconds.
à Door closes.
à Then the indicator light turns GREEN again.
7.6 Testing for acceptance
An acceptance test must be carried out in order to ascertain the correct function and installation according to
the regulations once the installation has been completed on site. Acceptance test to be performed by authorised
personnel; see document "Instructions for Installation, Commissioning, Operation and Maintenance of the GEZE
Hold-Open Device FA GC".
8 Maintenance, servicing, repairs
The installing company must alert the operator of the system to this part of the mounting instructions and hand
it over to the operator together with the user information (see ‚GEZE user information for door closer'). Regular
servicing has to be carried out. For more information on this, please observe the document "Instructions for
Installation, Commissioning, Operation and Maintenance of the GEZE Hold-Open Device FA GC".
Maintenance, servicing, repairs
GB 9