be cool BC16SFRC Bedienungsanleitung Seite 157

Assembly of rotor blade and protective grid
Step 1: Remove the rotor and the plastic nut
from the front of the motor. Attach the rear grille
and the plastic nut to the motor shaft and tighten
the plastic nut. Take the plastic ring out of the
packaging and push the ring of the rear grille into
the deep groove of the plastic ring.
Step 2: Remove the PVC sleeve from the shaft.
Insert the blade into the shaft and make sure the
locking pin is engaged in the groove of the blade.
Screw the rotor anticlockwise to tighten the
blade.
Step 3: After you have set up the centre piece of
the front grill, slide the ring of the front grill into
another slot of the plastic ring and tighten the
screw in the joint of the ring with a screwdriver.
Caution: To avoid risks, make sure the plastic
ring connects the front and rear grills before use.
Page 157 from 162
tighten
solve
Mother
2
Mother
Rotor blade
1
Notch
3
Locking pin
3