Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4 English
5.5 Twist pump plug slightly and pushing it into
the pump socket. Then twist LED light plug
slightly and pushing it into the light socket.
Make sure the sealing ring is fully in groove
Solar panel
[AUX1] Socket for
battery charger
(sealed)
[LIGHT] Socket
for LED light
6. PERFORMANCE
The performance of the pump depends on the orientation of the solar panels toward the sun and the intensity of the
max. Data obtained under optimal conditions. Function in the shade or on cloudy days can not be guaranteed.
In models with battery operation depends on the function of the battery is charged.
l Press ON/OFF button on back side of the solar panel to turn on the pump. The battery indicator lamp will be on.
With „Press" is always meant „touching", because a sensor is used as a „Pushbutton".
l Press ON/OFF button on back side of the solar panel to turn off the pump. The battery indicator lamp will be off.
l The LED light only works, when day goes dark.
l When battery power is low, the system will automatically shut off the pump to protect the battery. The indicator lamp
will be off in this case. The pump can not work, until the battery is recharged. The recharging time should depend on
sunlight conditions.
l The charging process will be interrupted as soon as the battery is fully charged to prevent overcharging.
l The pump will automatically start next morning, when solar panel receives enough sunlight.
NOTE: The battery is supplied charged. If the state of charge, contrary to expectations, not be sufficient to char-
ge the batteries for at least 8 hours to allow sufficient charging of the battery (so damage the battery to avoid
overcharging, the pump must be connected).
7. WARNINGS ON BATTERY
Lithium Ion cells and battery may get hot, explode or ignite and cause serious injury if they are
exposed to abusive conditions, Be sure to follow the safety warnings listed below:
l Do not install the battry backwards, so the polarity is reversed
l Do not connect the positive or/and negative terminal or/and the battery to each other with any meta object, such as wire
l Do not disassemble or modify the battery. The battery contains safety and protection devices which may cause the
battery to generate heat, explode or ignite if damaged
l Do not place the battery in or near fire, on stoves or other high temperature locations. Do not place the battery iiin
direct sunlight or use/store the battery inside cars during hot weather. Doing so may cause the battery to generate
heat, explode or ignite
l It is not advised for children to handle the battery
l When the battery is worn out, wrap the terminals with adhesive tape or similar materials before disposal
l Immediately discontinue use of the battery, if there is an unusuak smell, a change of color or shape, or if it appears
abnormal in any other way
l Do not place the battery in microwave ovens, high pressure containers or on cookware facilities
l In the event of the battery is leaking and fluid gets into your eye, do not rub the eye, rinse well with water and imme-
diately seek medical advice. If left untreated, the battery fluid could cause serious injury to the eye
Battery indicator
lamp
ON/OFF
Button
[PUMP] Socket
for pump
5.6 Now your new cascade is
assembled and ready for use
Werbung
