Braun CareStyle 7144 Bedienungsanleitung Seite 17

The closure is diffi cult to
unscrew.
After refi lling the water tank,
the light does not reset.
All LEDs are fl ashing.
Steam icon is permanently on,
but there is no steam emission
from the soleplate.
Steam or water comes out
from the closure.
The double cord gets hot
during use.
5712811931_CareStyle_7143_7144_7155_7156_INT_S6-152.indd 17 5712811931_CareStyle_7143_7144_7155_7156_INT_S6-152.indd 17
Lime scale has made the closure
diffi cult to open.
The boiler is still under pressure.
The water fl oat does not work
appropriately.
The water tank is not positioned
correctly.
System error.
Water tank fl oat is locked or
the water tank is not correctly
inserted.
The closure is not tightened
properly.
This is normal. It is caused due
to the steam passing through the
cord during ironing.
Turn the cap forcefully. To avoid the
problem, rinse system frequently.
Never open the closure if the boiler
is still under pressure or hot. Wait at
least 2.5 hours before opening the
closure.
Empty the water tank, rinse out and
refi ll.
Position the water tank correctly.
Unplug the appliance, plug it in
again and press On/Off button. If
this problem is still present, turn the
appliance off immediately, unplug
and contact an authorised Braun
Customer Service.
Turn off and unplug the appliance.
Remove and empty the water tank,
rinse out and refi ll. Insert the water
tank.
Switch on the appliance and wait
until the device is ready to use.
Press the steam button and wait
until steam comes out.
Keep the steam button pressed for
10 seconds of steam emission then
release the steam button.
Switch off the appliance, unplug
and let it cool down (for at least
2,5 hours).
Unscrew the closure and screw it
back on the appliance properly.
Note: Some water can escape
when you unscrew the closure
Place the double cord on the
opposite side so that you cannot
touch the cord during ironing.
17
27.10.17 08:22 27.10.17 08:22