Kidde Excellence Serie Installationsanweisungen

Excellence Series Intelligent Addressable Single
Input Module Installation Sheet
EN DE ES FR IT NL PL PT SV
1
EN: Installation Sheet
Figures
Figure 1: Device overview
(1) Mounting holes (×4)
(2) Loop terminal block
(3) Test (T) button
(4) Input terminal block
Figure 2: Input connections
(1) Normal mode
(2) Bi-Level mode
Description
This installation sheet includes information on the KE-IU3110
Intelligent Addressable Single Input Module (device type 1Ini).
The module provides a single remote input to an addressable
fire detection system.
The module includes an integrated short circuit isolator and is
suitable for indoor installation.
All 3000 Series modules support the Kidde Excellence protocol
and are compatible for use with 2X-A Series fire alarm control
panels with firmware version 5.0 or later.
© 2023 Carrier. All rights reserved.
(5) Input status LED
(6) DIP switch
(7) Device status LED
(3) Normally Open mode
(4) Normally Closed mode
2
Installation
WARNING: Electrocution hazard. To avoid personal injury or
death from electrocution, remove all sources of power and
allow stored energy to discharge before installing or removing
equipment.
Caution: For general guidelines on system planning, design,
installation, commissioning, use and maintenance, refer to the
EN 54-14 standard and local regulations.
Installing the module
Always use the NeXT System Builder application to calculate
the maximum number of modules that can be installed.
The module must be installed inside a compatible protective
housing (not supplied) − we recommend the N-IO-MBX-1 DIN
Rail Module Box. Remember to earth the protective housing.
Note: An alternative protective housing may be used providing
it meets the specifications indicated in "Protective housing" on
page 3.
Mount the protective housing onto the wall using a suitable
mounting system for the wall characteristics.
1 / 31 P/N 12-0201-501-4000-01 • ISS 21NOV23