SSS Siedle BTS 850-02 Bedienungsanleitung Seite 4

English
Accepting door calls
The ringing tones for the
front door and apartment
door are different. When a
visitor presses the door bell,
the telephone rings and the
mute button flashes.
The call can be accepted
within 45 seconds of the
last ringtone.
Actuating the door
release
When you press the door
release button, the door
from which the last call
came is opened for 3 sec­
onds.
Switching on the
light
When you press the light
button, the lighting is
switched on, provided this
has been connected by your
electrical installer.
Muting the bell
When the mute button
is pressed briefly, all the
ringing tones are switched
off or on again. The button
lights up red to indicate that
the mute has been acti­
vated. If a visitor rings the
doorbell, the button flashes
for as long as the hands­
free telephone is muted.
Selecting a door
station
Lift the receiver. Press the
light button twice to make
a speech connection to the
door station from which the
last call came.
Ringtone volume
The ringtone volume can be
set to 5 different levels:
4
With the receiver down,
press and hold down the
muting button for 3 sec­
onds to hear the set ring­
tone volume.
Press the mute button
briefly and the volume
increases by one level. After
the highest level it goes
back to the lowest level.
Save the selected
volume by pressing the
mute button for 3 seconds.
Ringtone melody
You can choose between
11 ringtone melodies. The
ringtone is always set for
the door from which the
last call came.
For this reason, first ring
the bell at the front door or
apartment door. (A different
ringtone melody can also
be selected for internal or
group calls).
With the
receiver down, press and
hold down the door release
and light button simultane­
ously for 3 seconds to hear
the set ringtone melody.
Pressing the muting
button changes the ring­
tone melody.
Save the selected ring­
tone melody by pressing the
mute button for 3 seconds.
Button assignment
The light, monitor­on and
mute buttons can also be
programmed with different
functions. For further infor­
mation, please contact your
electrical installer.