Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Switching the mains voltage on/off
-
Switching on
= Switch to position [ l ].
-
Switching off
= Switch to position [ 0 ].
When switching on the generator, the limit indicator will flash for 2 seconds.
After 2 seconds the background lighting on the display will slowly illuminate and information will
be shown about the generator. This information includes:
The generator type (e.g. "CM5-60N")
-
The firmware version
-
Additional information
-
This information is displayed for 2 seconds and then the generator continues to start.
When the generator is switched on for the first time or after the factory settings are reset, the
generator will first need to be set up via a quick configuration ('initial setup'). In all other cases
the generator will start normally and the main menu will be displayed. The generator always
starts up in the mode that was active when the generator was switched off.
Configuring the generator via the 'Initial setup' menu
on the screen. Then press [
be used for operating the CM5. The following text will then appear:
"Use as standard ECM: YES"
Using the [ ] / [ ] keys, select until the option "YES" flashes on the display. Then press [
confirm the choice
. The following text then appears:
"Remote HV On/Off Source: Continuous"
Using the [ ] / [ ] keys, select until the correct option flashes on the display. You can choose to
continuously switch on the output voltage ("Continuous") or to switch the output voltage on and
off remotely via the external hardware input ("External"). Then press [
choice
. The CM5 can now be used as a replacement for an ECM. The main screen of the CM5
will then be displayed.
CM5_QM_9752090135_NL_D_GB_F_IT_V2_2
] to confirm the choice
The 'Initial setup' or quick
configuration menu is used to
quickly configure the generator.
The generator can be used
immediately after configuration.
As soon as "[Initial setup]"
appears in the display, this
means that the generator still
needs to be configured for use.
Set the following parameters:
"Language: English"
Using the [ ] / [ ] keys, select
until the desired language
option "English", "Deutsch",
"Italiano" or "Français" flashes
. From now on, the selected language will
] to confirm the
] to
GB
19
Werbung
