Buffering Setting In The Portable Measuring Instrument; Loading Setting From The Portable Measuring Instrument Buffer; Initialising Measuring Module - Kemper CONTROL-PLUS Montage- Und Bedienungsanleitung

Buffering setting in the portable
3.4
measuring instrument
Meas. module
Meas. module name
Sensor setup
save to meas. module
save in handheld device
Loading from the buffer of the portable
3.5
measuring instrument
Meas. module
load from handheld device
Initialize
back...
3.6

Initialising measuring module

Meas. module
load from handheld device
Initialize
back...
Info
The configuration for the connected measuring module
is saved on the buffer of the portable measuring
instrument. This can then be used for the configuration
of other measuring modules.
Attention!
Use a configuration from the portable measuring
instrument buffer on the connected measuring module.
To accept the configuration on the measuring
module even after separation of the portable
measuring instrument, it is essential to save it in
the measuring module!
Info
When you are initialising, reset the measuring module
to factory settings.
All of the settings made before are lost in the process!
© www.kemper-group.com – 01.2024 / K410013800005-00 – 67 /184
3.3