Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area. Your
local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
Please follow the steps below for adjustment in salt consumption.
1 Open the door and switch on the appliance;
2. Press the Menu button to select Add. Salt Cons. ;
3. Press the Page-up or Page-down button to select the proper set according to your local
environment, the sets will change in the following sequence:
H1->H2->H3->H4->H5->H6;
4. Press the OK button to end the set up model.
WATER HARDNESS
German
French
dH
fH
0 - 5
0 - 9
6 - 11
10 - 20
12 - 17
21 - 30
18 - 22
31 - 40
23 - 34
41 - 60
35 - 55
61 - 98
1°dH=1.25 °Clarke=1.78 °fH=0.178mmol/l The manufactory setting: H3
Contact your local water board for information on the hardness of your water supply.
*Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
energy consumption increases by 0.02 kWh and the program extents by 4 minutes.
British
Mmol/l
Clarke
0 - 6
0 - 0.94
7 - 14
1.0 - 2.0
15 - 21
2.1 - 3.0
22 - 28
3.1 - 4.0
29 - 42
4.1 - 6.0
43 - 69
6.1 - 9.8
Water softener
Regeneration occurs
level
every X program
sequence *)
H1
No regeneration
H2
10
H3
5
H4
3
H5
2
H6
1
Salt
consumption
(gram/cycle)
0
9
12
20
30
60
Werbung
