Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4 Fill the detergent dispenser
Please check the section 1 "Water Softener" of PART 2: Special Version, If you need to set
the water softener .
Loading The Salt Into The Softener
NOTE:
If your model does not have any water softener, you may skip this section. Always use salt
intended for dishwasher use.
The salt container is located beneath the lower basket and should be filled as explained in
the following:
Warning
Only use salt specifically designed for dishwashers use!
Every other type of salt not specifically designed for dishwasher use, especially table salt,
will damage the water softener. In case of damages caused by the use of unsuitable salt the
manufacturer does not give any warranty nor is liable for any damages caused.
Only fill with salt before running a cycle.
This will prevent any grains of salt or salty water, which may have been spilled, remaining
on the bottom of the machine for any period of time, which may cause corrosion.
Please follow the steps below for adding dishwasher salt:
1 Remove the lower basket and unscrew the reservoir cap.
2 Place the end of the funnel (supplied) into the hole and pour in about 1.5kg of dishwasher
salt.
3 Fill the salt container to its maximum limit with water, It is normal for a small amount of
water to come out of the salt container.
4 After filling the container, screw back the cap tightly.
5 The salt warning light will stop being after the salt container has been filled with salt.
Werbung
