EINHELL TC-DY 710 E Originalbetriebsanleitung Seite 14

comes up against the workpiece and the coupling
disengages.
5.2 Changing the tool insert
To change the tool insert, rotate the screwing
depth stop (1) with the depth setting ring (2) as far
as the maximum screwing depth and pull off the
tool insert to the front (use pincers if necessary).
5.3 Screwdriving work
It is advisable to use self-centering screws (e.g.
cross recessed head) as these will enable you to
work safely and reliably. Always make sure that
the tool insert used is of the same size and shape
as
6. Operation
6.1 ON/OFF switch (Fig. 3/Item 4)
To switch on:
Press the ON/OFF switch (4)
Continuous operation:
Secure the ON/OFF switch (5) with the locking
button (4).
To switch off :
Press the ON/OFF switch (4) briefl y.
6.2 Clockwise/Counter-clockwise switch
(Fig. 3/Item 3)
•
Change switch position only when the drill is
at a standstill!
•
Using the slide switch above the ON/OFF
switch (4) you can select the direction of rota-
tion of the screwdriver.
Direction
Clockwise
Counter-clockwise
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Anl_TC_DY_710_E_SPK13.indb 14 Anl_TC_DY_710_E_SPK13.indb 14
GB
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Switch position
Article number of the unit
•
Arrow forward
ID number of the unit
•
Spare part number of the required spare part
Arrow backwards
For our latest prices and information please go to
www.Einhell-Service.com
- 14 -
Tip! For good results we
recommend high-quality ac-
cessories from !
www.kwb.eu
welcome@kwb.eu
05.04.2023 10:07:56 05.04.2023 10:07:56