FLINQ Xyro Bedienungsanleitung Seite 6

Manuel
EN
Note: if you are using multiple lamps (2 or more) with 1 remote control then only the
normal white and static colors will work together and simultaneously to operate as well
as the dim setting etc. The symphonic (moving colors) can NOT be run simultaneously
as this is technically not possible and will continue to work independently.
To reconnect and use the remote control with only 1 lamp in one room/area
works as follows:
Note: In this process, be sure to turn off other purchased lamps FIRST before pairing.
You must do this by unplugging the adapter.
1. Plug the adapter into the outlet of the lamp you want to pair and make sure the
lamp is ON.
2. Put the lamp into "color mode" by pressing the "light switch" button once if the lamp
is in normal white color mode.
3. Press and hold the LIGHT SWITCH button until the lamp flashes the light 5 times
rapidly in the color BLUE to confirm that 1 remote control is now paired.
4. Now remove the adapter OUT of the power outlet.
5. Repeat steps 1-3 above for any additional lamp(s) to be able to use them again with
1 remote control.
Read and follow all safety instructions
- This IP20 product is suitable for indoor use.
- Please use the rated input voltage power supply of the product as mentioned on the
back label.
- Do not install near a gas device or other sources with a similar heating process.
- Do not use the product outside its intended use.
- Read and follow all instructions that are indicated on the product or supplied with it.
- Keep this manual for future reference.
Register / login to the FlinQ app
1. Launch the "FLINQ" Application
2. Tap "agree" to confirm the privacy policy
3. To register, enter your mobile phone number or email address.
4. Press "verification code retrieval"
5. Enter the "verification code" that was send by phone number or email address
6. Create a password and login for the new app use or go to Login if you already have
an existing account.
Make sure your mobile device is running iOS 9 & higher or Android 5 & higher and
Bluetooth is turned ON!
Important
Make sure that the lamp is set up, placed and powered ON during the 1st setup and
within a range of 10 meters max between your mobile device and the lamp itself.
When turned ON by the adapter the red LED will quickly flash to indicate it's ready
to pair/connect by the Wifi/BLE function. TIP: If it fails to flash quickly in red pairing
function, just check the remote functions described above to restore the pairing
factory setting.
Tip: For users that don't want to use the lamp by the FLINQ app, they can wait for
the red led light flashing for more than 3 minutes so the lamp will be automatically
working with the remote control.
FlinQ Smart Indoor Xyro Floorlamp