Installation Of The Lamp - FLINQ Xyro Bedienungsanleitung

Manuel
EN

Installation of the lamp

Do not connect the power cable nor adapter to the power mains outlet yet!
Please check if the lamp set is complete according the package contents as described.
1 Place lamp on table
Place the lamp pole carefully on a table
that is protected by a soft cloth or towel
etc.
5 Clean batterie contacts
Clean the battery contact and remote
contacts before installing the batteries.
2 Attach the base to the lamp pole
Take the lamp pole bottom screw side in one
hand and bolt it with your other hand on the
lamp foot base hole with the supplied tool
and bolt. Fix it fi rmly but slow, carefully.
6 Place batteries
Install the three batteries 1 by 1 and
make sure to use the correct polarity +
and – inside the remote control housing.
Note: The power adapter input is AC100-240V 50/60Hz, 0.7A with output from DC
12V-2A (2000mA) 24W max. Keep in mind this adapter is not waterproof and needs
to be used only indoors.
3 Insert cable
Insert the USB connector cable end
included into the approved adapter
power connection to connect and insert
it to the mains power outlet.
7 Place cover back
Put the battery cover back into its place
and make sure that all sides are correctly
"clicked" and pushed inside the housing
of the remote top housing.
FlinQ Smart Indoor Xyro Floorlamp
4 Open remote control
To open the battery cover at the back
side use a small coin to twist and open it
at the side of the remote back cover.
Note: The remote can be used for the
change of colors, to dim the light, to
speed up or down, start/pause function
controls and more. The remote control
is not waterproof! The maximum
control distance is <30 meters without
obstacles and in open space.