Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WATER DISPENSING
• Place the device on a flat, stable surface, in a place where it cannot fall over.
• Remove the water tank cover and fill the water tank with clean water. Make sure the water tank is filled
at least above the "MIN" mark and not above the "MAX" mark on the water tank.
• Use can either fill in water by taking out the water tank or adding water directly to water tank without detaching the
water tank from main unit.
• DO NOT fill in water with temperature over 40
℃
.
• There are holes in the tank above the "MAX" indication mark, which will release water in case of overfilling and
avoid vacuum from being created in the tank compartment.
• Close the water tank by placing the water tank cover back on the water tank.
• Place your cup on the removable drip tray and make sure it aligns with the spout.
• Press and hold the Lock button to unlock he control panel. Select the desired temperature and volume. Press
On/Off button.
• After ± 5 to 10 seconds the device starts to dispense water. User can press On/Off button to stop the operation.
Calibrating water temperature and volume
If users find the water temperature and volume is not accurate, user can perform a calibration process:
• Fill water in water tank to MAX level, press and hold Temp. button for 3 seconds.
• Temperature will display AUT, and Volume will display 000
• Press On/Off button before device goes to Lock mode. After that, device will enter the calibration mode: from 45-
55-65-75-85-100 sequentially. It will exit the calibration mode automatically after the process is completed.
• The calibration process takes about 4-5 minutes. Wat will flow out from dispensing nozzle during the process. Put
a large container under the dispensing nozzle to hold the water.
Remarks:
• If the device stops with beep and "E7" is shown on display panel, this means water tank is out of water. Need to fill
in cool water in water tank immediately.
• The device can memorize the last operation mode unless the power plug is disconnected from the mains.
• To have best performance of the memories function, it is recommended to operate the device for at least 60 seconds
after plugging in the device to the mains.
• Water volume dispensed may vary
± 15% due to variation of ambient temperature in different time.
7
Werbung
