Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Lock button: press and hold Lock button for 3-5 seconds to unlock. If there is no keypress within 10-15 seconds, the
panel will go to lock mode again. User can also lock the panel by pressing the Lock button.
Temp. button: press Temp. button to set desired temperature (45℃, 55℃, 65℃, 75℃, 85℃, 100℃, or 000(normal
temperature water))
Volume button: press Volume button to set water volume (100ml, 200ml, 300ml, 400ml, or 000(disperse water
continuously))
Milk button: add appropriate milk powder in bottle or cup, press and hold Milk button. Water with temperature 40℃
will be dispensed continuously and user can stop the water dispensing by releasing the Milk button
Coffee/Tea button: press Coffee/Tea button and 92℃, will be shown on display. Select desired
volume(000(continual), 100ml, 200ml, 300ml, 400ml). Press On/Off button to start.
On/Off button: start and stop function setting
Descaling: When operating time cumulated to 10 hours, Descaling light will flash to remind the user to do the
descaling process.
Fill water tank to maximum level, add some citric acid or vinegar into the water and press and
hold Volume button for 3 seconds to enter the descaling process.
Press On/Off button to start the decaling process. Water will be dispensed. After all the water from water tank is
dispensed, the descaling process is completed, and the descaling light will be off again.
Lack of water: When water in the water tank is less than the MIN level, "E7" and "Lack of water" will flash to remind
user to refill water in water tank.
First use:
• Remove the device and accessories from the box. Remove any stickers, protective film, or plastic from the
device.
• Make sure the plug is removed from the power socket.
• Before you use the device for the first time, wipe all the removable parts with a damp cloth. Never use
aggressive or abrasive cleaning materials, a scouring sponge or steel wool; this will damage the device.
• Clean the water tank before first use. Fill the water tank with clean water, remove the water from the water
tank by turning over the device, dry the water tank compartment with a dry cloth. Repeat these steps ± 3 times.
• Do not use any washing up liquids in the water tank!
• Place the device on a flat, stable surface, in a place where it cannot fall over.
• Connect the device to the mains power.
• The device is now ready for use.
6
Werbung
