Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OBJ_BUCH-1168-001.book Page 43 Friday, April 16, 2010 5:25 PM
Replacing Insert Plates (see figure M)
The red insert plates 10 can become worn after
long use of the machine.
Replace defective insert plates.
– Bring the power tool into the working posi-
tion.
– Unscrew the screws 48 using the provided
Phillips screwdriver and remove the old in-
sert plates.
– Insert the new right-hand insert plate.
– Screw the insert plate as far as possible to
the right with the screws 48 so that the saw
blade does not come into contact with the in-
sert plate over the complete length of the
possible slide motion.
– Repeat the work steps in the same manner
for the left-hand insert plate.
Sawing
Sawing without Slide Movement (Cutting Off)
(see figure O)
– For cuts without slide movement (small
workpieces), loosen the locking screw 25 in
case it is tightened. Slide the tool arm to the
stop in the direction of the fence 18 and
retighten the locking screw 25.
– Firmly clamp the workpiece as appropriate
for its dimensions.
– Set the desired mitre angle.
– Switch on the machine.
– Push the locking lever 35 and guide the tool
arm slowly downward with the tool handle 5.
– Saw through the workpiece applying uniform
feed.
– Switch off the machine and wait until the
saw blade has come to a complete stop.
– Guide the tool arm slowly upward.
Bosch Power Tools
Sawing with Slide Movement
– For cuts using the slide device 1 (wide work-
pieces), loosen the locking screw 25 in case
it is tightened.
– Firmly clamp the workpiece as appropriate
for its dimensions.
– Set the desired mitre angle.
– Pull the tool arm away from the fence 18 far
enough so that the saw blade is in front of
the workpiece.
– Switch on the machine.
– Push the locking lever 35 and guide the tool
arm slowly downward with the tool handle 5.
– Press the tool arm in the direction of the
fence 18 and saw through the workpiece ap-
plying uniform feed.
– Switch off the machine and wait until the
saw blade has come to a complete stop.
– Guide the tool arm slowly upward.
Adjusting the Depth Stop (Sawing Grooves)
(see figure N)
The depth stop must be adjusted when a butt
gap is to be sawed.
– Turn the depth stop lever 47 in anticlockwise
direction to the stop (approx. 90°).
– Screw the depth stop 23 completely upward
turning in anticlockwise direction.
– Lower the tool arm by the handle 5 to the de-
sired position.
– Screw the depth stop in clockwise direction
until the screw end touches the lever 47.
– Guide the tool arm slowly upward.
– To obtain the full cutting depth again, turn
the depth stop lever 47 in clockwise direc-
tion back to the stop.
Special Workpieces
When sawing curved or round workpieces,
these must be especially secured against slip-
ping. At the cutting line, no gap may exist be-
tween workpiece, fence and saw table.
Provide for special fixtures, if required.
1 609 929 W28 | (16/4/10)
English | 43
Werbung
