Werbung
Verfügbare Sprachen
Verfügbare Sprachen
en
Approx. 600 ml water will be rinsed through the system. Keep an eye on
the container and empty it before it overflows.
On completing rinsing, the machine will emit a beep and automatically
switch into standby mode. The indicator light will go out. The descaling
process is then complete.
Problems / solutions
The indicator light is
Is the water tank empty?
flashing red and there are
• Fill the water tank with fresh water.
several beeping sounds.
• Press one of the beverage buttons.
113420 en Cafissimo Pure+ v6.indd 36
113420 en Cafissimo Pure+ v6.indd 36
17. Press the Caffè crema button
to start the rinsing process.
The rinsing phase will begin.
The Caffè crema button will
fade and the indicator light will
flash yellow. The procedure
takes approx. 2 minutes.
The pump will start to operate. As soon as
the pipes are filled with water, the pump
stops automatically. When the beverage
buttons light up constantly, the machine
is once again ready to use.
The indicator light is
Did you insert a capsule during the
initial start-up procedure?
flashing red and there are
several beeping sounds.
• Open the lever to allow the used capsule
to fall into the used capsule container and
the pressure to escape from the machine.
You must now repeat the start-up proce-
dure. Proceed as described in the chapter
"Initial operation – prior to first use".
There are coffee grounds
• A small residue of coffee grounds always
in the cup.
remains at the bottom of the cup. This is
a feature of the system and is not a fault.
The coffee is not hot
• Especially in the case of espresso, the quan-
enough.
tity of coffee is so small compared to the
size of the cup that it cools down quickly.
Preheat the cup by filling it with hot water
and pouring it away shortly before using
the cup.
Water is dripping from
• The water in the system expands as the
the beverage spout.
machine heats up This causes a little
water to drip from the beverage spout.
The indicator light stays
• The machine needs to be descaled.
yellow.
Do this within the next couple of days.
Do not wait any longer, otherwise the limes-
cale build-up may become too extensive for
a descaling agent to have any effect.
A self-induced defect of this kind will not be
covered by the warranty. Proceed as de-
scribed in the chapter "Descaling".
36
06.01.23 15:20
06.01.23 15:20
Werbung
