Operation - cecotec SPRINT Bedienungsanleitung

Assembling the pedals. Fig. 5
1. Check the marking indicating the left pedal and the right pedal. You will find stickers
indicating this.
2. To mount the pedals, the right pedal must be screwed clockwise, and the left pedal must
be screwed counterclockwise with the 15 mm spanner.
Assembling the battery. Fig. 6
The electric bicycle includes a battery. Remove it from the box carefully.Place it in the space
provided for it in the diagonally positioned central tube. Slide it in after making sure that the
battery is correctly aligned.
Press the button on the front end of the battery to ensure that the power supply is connected
and functioning properly.
Battery removal
To facilitate proper recycling of the product, follow these steps to remove the battery:
1. Unscrew the protective cover at the bottom of the frame. Once the cover is removed,
remove the battery retaining screws and remove the controller and battery assembly.
2. Finally, disconnect the cables that connect the controller and the battery.
NOTE:
Removal of the battery should only be done for the purpose of recycling the appliance.
Charging the battery
Only use the original charger supplied. To start charging, insert the charger into the socketon
the side of the battery and plug it into a power source. The battery will fully charge in 5-6 hours.

4. OPERATION

Fig. 7 key:
Icons
1. Battery level
2. Multifunction display area (unit: mile, km):
DIS: current trip mileage.
ODO: total mileage.
3. Speed display area, (unit: Mp/h, km/h). The motor sends the speed signal to the controller.
The console calculates the actual speed based on wheel diameter and signal data.
4. Assistance modes/gear display area
5. E-bike indicator lights:
: settings menu
07217_52_Bicicléta eléctrica_Sprint_Sprint Silver_IM_AP_01240122.indd 85 07217_52_Bicicléta eléctrica_Sprint_Sprint Silver_IM_AP_01240122.indd 85
ENGLISH
85
SPRINT | SPRINT SILVER
22/1/24 12:26 22/1/24 12:26