Werbung
Verfügbare Sprachen
Verfügbare Sprachen
- Check the power cable regularly for visible damage. If the
power cord is damaged, it must be replaced by the official
Cecotec Service Centre or similarly qualified personnel to
avoid hazards.
- Make sure that the mains voltage matches the voltage
stated on the rating label of the appliance and that the wall
outlet is earthed.
- Do not twist, bend, pull, or damage the power cable. Protect
it from sharp edges and heat sources. Do not allow the cable
to touch hot surfaces. Do not let the cable hang over the
edge of the working surface or worktop.
- Do not immerse the cable, plug, or any other part of the
appliance in water or any other liquid or expose electrical
connections to water. Make sure your hands are dry before
handling the plug or switching on the appliance.
- Avoid contact with the steam emitted by the appliance.
Steam temperature is very high and can cause burns and
other damage.
- The appliance is not intended to be operated by means of an
external timer or separate remote-control system.
- Switch off and unplug the appliance when not in use and
before cleaning it. Pull from the plug, not the cable, to
disconnect it from the outlet.
- Keeping the iron at maximum temperature for too long may
cause discolouration, which will not affect the performance
of the appliance.
- Do not try to repair the device by yourself. Contact the official
Cecotec Technical Support Service for advice.
Cecotec takes no responsibility for any damage caused by
misuse of the machine. Any misuse or non-compliance with
these instructions voids the warranty and Cecotec's liability.
8
IRONHERO 2600 FORCE
Werbung
