GLOBBER GO UP ACTIVE Benutzerhandbuch Seite 7

INSTALLATION AND USE OF SEAT FOR USE
ride-on / walking-bike (see page 2)
- GO•UP ACTIVE comes with a connector tube which is
used to fix the seat. There are 2 different seat heights
available: 25.4 and 28.7cm from the ground. For a
comfortable ride, the child's feet should easily touch the
footrest and the ground.
- Use the L-key in-pack to unscrew the handlebar. Insert
the handlebar into the seat, and then tighten the screw
to secure the handlebar.
- Attach the seat to the connector tube by sliding it on to
the tube. Select your preferred height, then tighten the
knob to make sure the seat is securely in place (see
diagram 1-2).
- Insert the connector tube into the integrated tube hole
at the front of the scooter deck between the two front
wheels. Make sure to insert the connector tube in the
correct direction following the arrow on the connector
tube (see diagram 3) and ensure the spring ball on
the side of the connector tube "clicks" into place, to
securely hold the seat frame (see diagram 3).
- Place the footrest on the deck in the correct direction.
Make sure the knob is tightened and securely fixed
(see diagram 5-6).
- Warning! Pull up the seat from the deck without
pressing the side push-button on the deck to check that
the seat connector tube is safely locked in place before
use.
Ride-on mode:
- Insert the handlebar tube in the back hole of the seat
support frame. Align the spring-loaded buttons with the
notches at the rear of the seat and lock the handlebars
(see diagram 4). Double check that the spring-loaded
button is engaged and locked correctly.
- Adjust the height of the handle to the parent's
preference (4 positions are available; see diagram A).
Loosen the quick release clamp of the T-bar handle
when adjusting. Tighten the quick release clamp to
secure the T-bar handle after adjustment.
- The parent handlebar can be used to accompany
children during use. Install the footrest (see diagram
5-6). Place the child's feet on the footrest and the adult
pushes using the parent handle (T-bar).
- Warning! An adult must always hold the parent handle
when the child's feet are on the footrest and both hands
are on the seat's handlebars to avoid the child falling.
Walking bike mode:
- Remove the handlebar tube in the back hole of the
seat by pressing the 2 spring-loaded balls.
- To remove the footrest, unscrew the knob on the
footrest, then remove the footrest. Once the footrest
is removed, cover the hole in the deck with the button
in-pack (see diagram 8-10).
- GO•UP ACTIVE comes with an adjustable seat which
can be adapted to the child's height (2 positions).
Unscrew the knob and slide up/down to adjust the seat
height. Align the seat through the screw holes in the
connector tube and retighten the knob.
- Warning! Make sure the child's feet can touch the
ground freely in seated mode before riding.
Steering: The child pushes with his/her feet on the
ground to advance, while the child's sitting on the seat.
He/she must proceed with caution at first.
7