GLOBBER GO UP ACTIVE Benutzerhandbuch Seite 6

Keep the instructions for future reference.
NF-EN-71
Warning! Protective equipment should be worn. Not to
be used in traffic.
20 kg max.: Seat mode (ride-on, walking bike)
50 kg max.: Scooter mode
Seat mode: Warning! Not to be used by children over 36
months due to the limited strength of the seat bracket
frame. The seat can only be used with this
product when the steering is completely locked by the
parents using the locking button located at the upper
side of the steering assembly. Press down the locking
button in order to lock the steering of the wheels when
the seat is to be mounted.
Remove the scooter and all the parts from the box. Set
out all the parts and read the assembly instructions prior
to use. Keep the packaging until assembly is complete.
General instructions
This toy must be assembled by a responsible adult.
Prior to use, make sure that the toy has been assembled
properly. Remove all the parts that are not necessary for
play before giving the toy to your child. The toy should
be used with caution since skill is required to avoid falls
or collisions causing injury to the user or third parties.
Use with suitable protective equipment, including a
helmet, shoes, elbow, wrist, and knee protectors. Teach
the child how to use it safely and responsibly.
6
Directions:
- T he scooter can be dangerous and can cause traffic
accidents when used on public highways. Don't use
on public roads. It is best used on a flat, clean surface,
free of gravel and grease. Avoid bumps and drainage
grates that may cause an accident.
- The scooter does not include any headlights or lights. It
is therefore not suited for use at night or during periods
when visibility is limited.
- Always use under adult supervision.
- Do not allow more than one child to ride the scooter at
the same time.
- Do not use on wet days or on wet ground.
- Store the product in a cool, dry place. Avoid direct
sunlight.
Before and after use:
- Make sure that all locking mechanisms are securely
locked:
- Check the height of the steering system, and make
sure the nuts are tightened and that the handlebars
and the front wheel are perpendicular.
- The minimum height of the T-bar has to be locked
at the lowest position by switching the bullet into the
lowest slot (see diagram A).
- Check all of the connection elements: The brake, the
steering column's quick release system, and the wheel
axles must be adjusted correctly and not damaged.
- Also check the tire wear.