CHAUFFAGE FRANCAIS ADROS Benutzerhandbuch Seite 26

Hydraulic connec�on:
The material of the water inlet and outlet pipework must withstand a pressure of 0.75 MPa and
temperatures in excess of 100°C. It is forbidden to use a pipe with a resistance lower than that
men�oned above.
As its colour indicates, the cold water inlet is marked in blue and the hot water outlet in red.
1. The dielectric fi�ngs are preinstalled at the factory.
2. Screw and fix the safety valve on the cold water inlet (blue colour).
3. In the case of a mul�-point water supply, adjust the water inlet and outlet pipes at the points
reserved for them respec�vely.
We would like to remind you once again that it is of the utmost importance that you ensure:
• The water inlet and outlet pipes must be made of a material capable of withstanding a
pressure greater than 0.75 MPa and a Temperature greater than 75°.
It is forbidden to use pipes with a resistance lower than that required.
The water inlet and outlet are clearly indicated. The blue colour corresponds to the cold
water and therefore to the water inlet and the red colour to the hot water and therefore to the water
outlet.