Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MODEL
Motor
Motor
Operating RPM
Ignition Switch
Drive shaft
Cutting head
Vibration Level
Sound pressure level
(no load)
Measured sound power
level (no load)
Guaranteed sound power level
(no load)
Cutting path diameter
Operating weight
Trimming line diameter
PROBLEM
• Motor will not start
• Cutting head will not turn
when throttle is squeezed
• Cutting head will not advance
line
All information, illustrations and specifications in this manual are based on the latest
product information available at the time of printing, We reserve the right to make changes
at any time without notice.
SPECIFICATIONS
ELT 738
Electric
7000-8000 g/m
Control switch
6,2 mm
"Bump Head"
reel feeding
1,65 m/s2 (700 W)
LPAm = 74,6 dB (A) (700 W)
LWA = 94,6 dB (A) (700 W)
LWA = 96 dB (A) (700 W)
370 mm (700 W)
4,9 Kg (700 W)
2,0 mm (700 W)
TROUBLESHOOTING
CAUSE
1. Motor stops / will not start
2. Cutting head bound with
grass or debris
1. Flex shaft broken
2. Flex shaft not engaged
1. Cutting head out of line
2. Inner reel bound up
3. Cutting head dirty
4. Indexing teeth worn or
burred
5. Line welded
6. Line twisted when refilled
7. Nut enough line is exposed
ENGLISH
ELT 1040
Electric
7500 - 8500 g/m
Control switch
6,2 mm
"Bump Head"
reel feeding
2,15 m/s2 (1000 W)
LPAm = 75,75 dB (A) (1000 W)
LWA = 95,36 dB (A) (1000 W)
LWA = 96 dB (A) (1000 W)
370 mm (1000 W)
5,5 Kg (1000 W)
2,0 mm (1000 W)
ACTION
1. Check curd to see if it is
plugged into an electrical
outlet
2. Stop motor and clean cutting
head
1. Contact service dealer
2. Contact service dealer
1. Refill with new cutting line
2. Replace inner reel
3. Clean inner reel and outer
spool
4. Replace inner reel and outer
spool
5. Disassemble, remove the
welded section and rewind
the line
6. Disassemble and rewind reel
7. Push the Bump Knob and
pull out 102 mm of line until
the line is outside of the
cutting head
7
Werbung
