DYNAFIT HOJI Bedienungsanleitung Seite 5

TF CUSTOM READY – CUSTOM LIGHT: Always refer to an authorized DYNAFIT retailer
when molding your liners. In order to get the best fit and to be covered by the warranty
we recommend using only blowing heat towers shown on the picture (1) and not others
heating systems.
MOLDING LINERS: Remove the footbed (if present) before heating the liner. Warm up
the liners with air blowing heating system. Do all shaping with the liners in the boots, do
not warm up the liners separately from the shells to avoid damaging them. During the
heating time prepare your feet wearing the socks you usually use during the activity, put
the toe caps on your toes in order to gain room on the toe box (2) and the Nylon socks
useful to slip into the boot (3). Just a bit before the count down is finishing, take out
the first boot and leave the second one on the machine. Place the footbeds (if needed)
back into the boot before stepping in. Place your foot into the boot helping you with a
shoehorn. Close the boot into downhill mode to a level of medium tightness. Remain in a
stable standing position and wait at least 10 minutes to allow the liner to cool down and
walking on the heels in the first 10 seconds. Repeat these points for the second boot.
External abrasion on Thermoformable liners is normal. In the boot box, special patches
are provided to reinforce your liners if you start to see abrasion occurring on the outside
of the liners.
CARE AND MAINTENANCE OF YOUR DYNAFIT BOOTS:
• Use only mild soap and water to clean your boots.
• If the liners are wet, remove them from the shells. Take out the footbeds and place
them in a warm, dry place. Keep them away from direct heat sources, such as radia-
tors, fireplaces, or ovens, as this may cause damage or change the fit.
• Before storing the boots for an extended period of time, be sure the liners and shells
are completely dry. Place the liners in the shells and close the buckles loosely.
• With time and sun exposure, the coloration of the boots may change. Especially the
white color could become less bright. To preserve the color of your boots we suggest
that you store them in their box or in a place protected from direct sunlight.
LIFETIME GUARANTEE:
The DYNAFIT warranty covers all manufacturing and
material defects for 2 (two) years from the date of
purchase. If registering your ski boot under
com/product-service you can extend it into a Lifetime
Guarantee of 5 years. The Lifetime Guarantee is only
available to the original/first owner of the product
All DYNAFIT ski touring boots are guaranteed against
manufacturing or material defects for 5 years.
Note - normal wear and tear (damage that naturally and inevitably occurs as a result of
normal use), misuse, modification, unauthorized repairs and improper care of your boots is
excluded and not covered.
For all defects covered by the Lifetime Guarantee, DYNAFIT will replace or repair the
product at their sole discretion. The buyer should either return the clean and dry boots to
the place of purchase with proof of purchase or claim the product directly via dynafit.com.
dynafit.