DYNAFIT HOJI Bedienungsanleitung Seite 4

comes about by engaging the ski/walk lever at the back. To guarantee proper closure
tension, move the ski/walk lever into the SKI position.
• ULTRA LOCK STRAP (PRO/FREE version): The Ultra Lock Strap on the upper area of
the cuff is vital for the correct operation and safety of the ski touring boot. PLEASE
NOTE: This strap gives the ski touring boot progressive flexibility when skiing. The
function of the strap correlates to that of a buckle closure system. Thus, it is essential
for the strap to be closed when skiing.
• VELCRO STRAP (PX/PU version): For the PX/PU version, thread the Velcro strap
through the metal ring. By pulling on the Velcro and the attached connection, you can
achieve a normal adjustment.
• HOJI LOCK SYSTEM Using the rear lever, you can move between the ski and walk
mechanisms with one simple movement. In addition, the PRO/FREE version allows you
via a screw adjustment to compensate for any possible slippage caused by wear and
tear of the components.
NOTE: The ski touring boot is delivered from the factory with the minimum setting.
Only change the screw adjustment if needed and upon the assistance and advice of an
authorized retailer.
USE:
ENTERING AND ADJUSTING
1. Open the buckles and lever, and pull open the tongue on the cuff. Check to see if the
ski/walk lever is in the "walk" position with the lever in the upper position.
2. If not yet done, place the boot liner into the shell. Take care that the sealing gasket
(the piece between the spoiler and shell made of synthetic materials) is not crunched
or compressed.
3. Now pull on the boot: Place your foot in it and adjust the tongue back into the correct
position.
4. Close the lower buckle.
5. Close the ratcheting buckle at the instep.
6. Move the ski/walk lever into the "ski" position with the level in the lowest downward
position.
7. Now adjust the fit of the cuff buckle.
8. Close the Ultra Lock Strap i.e. attach the Velcro strap.
9. Place the ski/walk lever into the "walk" position with the lever in the uppermost position.
• WALK MODE After you have fine-tuned all of the fit adjustments as described in the
section "Entering and Adjusting," move the ski/walk lever into the "walk" position with
the lever in the uppermost position.
• SKI MODE After you have fine-tuned all of the fit adjustments as described in the section
"Entering and Adjusting," move the ski/walk lever into the "ski" position with the lever in
the lowest downward position. Do a few bending movements to facilitate the procedure.