Mottura tende & scorritenda MONO 373 Betriebsanleitung Seite 9

The Mono 373 system motor group is not suitable for use in rooms with risk of explosion and in
situations requiring a protection level higher than IP30.
For correct operation, the Mono 373 system requires an adequate power supply (110/220 V and 60/50
Hz frequency – see "Electrical connections" section), a structure that is strong enough to support the weight of
the system and the stress to which it is subjected, and room temperature between +10°C and +50°C.
Important safety instructions for installation and use
The installation and electrical connections must only be carried out by qualified technicians, with
suitable equipment and under safety conditions, following the instructions given in this manual.
The system must be installed so that the motor unit is at a minimum height of 2.5 m above ground (or
from the nearest access surface).
The button that operates the system must be installed outside operating area, at a minimum height of
1.5 m above ground (or from the nearest access surface) and within sight of the system.
All routine or extraordinary maintenance must be performed solely by qualified technicians after
disconnecting the system from the electrical power supply.
If any work needs to be done occupying the system operating space (e.g. cleaning glass, removing
fabric, etc.) prevent all possible activation of the system operating devices or disconnect the system from the
electrical power supply.
Only original parts must be used if any parts need to be replaced. Any use of non-original parts and
any adaptation or tampering will relieve Mottura S.p.A. of all liability for injury to persons or damage to
property.
Do not let children play with the operating devices. Keep the devices out of their reach.
Make periodic checks of all mechanical and electrical parts. Take steps to prevent the system from
being used if maintenance has to be done.
During normal system use, monitor its movement. Prevent anyone from entering the system operating
space until it is completely stopped.
Attachment "A" provide instructions for correct assembly and installation of the Mono 373 system.
To fasten the supports, use anchors or screws suitable for the type of structure
Make certain that the structure is adequately sized for the weight of the system.
Conditions of use
Assembly and installation
on which the system will be installed.
2