Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To control the Mono 373 by radio it must be assigned to a remote control. To perform this operation
carry out the following procedure (see attachment "D" fig "3D").
1. Put the transmitter into the association mode.
Consult the technical manual for the transmitter being used.
2. Press the R. F. button on the motor control panel for 5 seconds (one flash of the "R. F." LED on
the motor control panel confirms that the association procedure has been carried out correctly)
With the system completely closed, sending an opening command orientates the louvres completely
(at slow speed) followed by gathering.
There is no impulsive action, and so louvres orientation is achieved by starting and stopping the
system in the required condition. The slow speed during the start phase allows fine adjustment of the
louvres.
FAULT
The system does not move
The system does not stop
at the correct position
System blocks after
several consecutive
activations
Power requirement: 110-220 V / 60-50 Hz
Input: 55 W
Sliding velocity: 10 cm/s
Radio frequency chip reception frequency: 868 MHz - 915 MHz
Single control with SINGLE button
Simultaneous control with GROUP button
Manufactured to EU standards
Dimensions: 52 mm x 90 mm x 270 mm
Weight: 1,3 Kg
Assigning an R. F. radio receiver
Louvres orientation
Troubleshooting
POSSIBLE CAUSE
Limit stops incorrectly set
Incorrect wiring
No electrical power
Faulty motor unit.
R. F. association not
carried out
Limit stops incorrectly set
Obstructions in the curtain
work space
The power supply has
reached the heat protection
threshold
Technical Characteristics
Set the limit stops
Check and correct the wiring by following
the instructions in this manual
Restore electrical power
Request replacement of the motor unit.
Carry out the association procedure
Set the limit stops
Remove obstructions
Let the power supply cool for a few
minutes and try again.
4
REMEDY
Werbung
