Revitive Essential CIRCULATION BOOSTER Bedienungsanleitung Seite 9

Instructions for use
g
Press the Body Pads on the area you wish to apply electrical stimulation to, as
shown on page 14, gently pressing the adhesive side against the skin.
h
Press the power button on the Revitive.
You will hear a beep and the display lights will read 30 minutes.
To turn off the device at any time during operation, press the power button.
R
i
Press the
Press the (+) button to increase the level.
Press the (–) button to decrease the level.
R
j
Ensure you familiarise yourself with the feeling of Electrical Muscle Stimulation (EMS). Use on a low intensity
for 30 minutes once per day for a few days.
It is normal to feel tingling or varying sensations in your muscles you are treating.
k
After a few days of familiarisation, use a higher intensity that provides you with strong but comfortable muscle
contractions.
You can set the intensity between 1-50.
Please note that the intensity required may vary from day to day.
l
The time display will start to count down in minutes as Revitive cycles through its program.
m
When Revitive times out, the time display reads 00 and you will hear three beeps, and the device will
switch itself off automatically.
16
8034_IFU01_18976655.indd 17 8034_IFU01_18976655.indd 17
(+) Intensity Control one time to start stimulation.
R
R
If you feel pain or discomfort:
• Lower the intensity of the Body Pads using the (–) Intensity Control.
• You can also choose to stop therapy before the end of the 30 minute session to avoid skin irritation. You can do this
by pressing the power button.
n
Ensuring that the device has switched itself off, then gently peel the Body
Pads from the skin.
Do not pull the Body Pads off the skin using the Electrode cords as this
may damage the cords.
o
Replace the Body Pads onto its plastic liner after use.
p
Unplug the Electrode cord from the opening on the device.
You do not need to detach the Body Pads from the Electrode cord.
EN
17
08/02/2023 09:22 08/02/2023 09:22