Step 2: Using The Foot-Pads - Revitive Essential CIRCULATION BOOSTER Bedienungsanleitung

Instructions for use

Step 2: Using the foot-pads

a
It is important that you are hydrated. We recommend drinking a glass of
water before using Revitive.
Sit with both bare feet You may also apply a moisturiser to the soles of the feet to help hydrate
on the foot-pads
the skin.
Hint: Applying a moisturising lotion to the soles of the feet before using
Revitive can help improve the delivery of electrical stimulation.
b
Get into a comfortable seated position.
For best results sit with your knees at a 90 degree angle (right angle).
c
Place Revitive on the floor in front of you.
Revitive is designed to be used while seated.
Never stand on the Revitive unit.
d
Place both bare feet on the foot-pads. Make sure you remove all footwear,
including socks/stockings.
e
Press the power button on the Revitive.
You will hear a beep and the display lights will light up.
The
To turn off the device at any time during operation, press the power button.
R
f
Press the
Press the (+) button to increase the level.
Press the (–) button to decrease the level.
R
g
Ensure you familiarise yourself with the feeling of Electrical Muscle Stimulation
(EMS). Use on a low intensity for 30-60 minutes once per day for a few days
Set the intensity at a level where you can feel the stimulation in your feet and
which creates a calf contraction.
It is normal to feel tingling or varying sensations in your calf muscles.
Revitive does not vibrate.
12
8034_IFU01_18976655.indd 12-13 8034_IFU01_18976655.indd 12-13
time will read 30 minutes and Intensity will read 00.
(+) Intensity Control one time to start stimulation.
R
R
h
After a few days of familiarisation, use a higher intensity that provides you with strong but comfortable calf
muscle contractions.
Most people experience a strong contraction at intensity level 40 or over. You can set the intensity between
1-50.
Please note that the intensity required may vary from day to day.
If you feel pain or discomfort:
• Remove one or both feet from the foot-pads to stop the stimulation.
• Lower the intensity of the foot-pads using the
replacing your feet on Revitive.
i
The time display will start to count down in minutes as Revitive cycles through its program.
j
When Revitive times out, the time display reads 00 and you will hear three beeps.
k
The Revitive switches itself off automatically.
EN
(–) Intensity level button on the control panel before
13
08/02/2023 09:22 08/02/2023 09:22