Saro ECO Betriebsanleitung Seite 16

GENERAL NOTES
• Keep this operating manual readily available near the appliance.
• The manufacturer/dealer cannot be held responsible for damages resulting from non-compliance with this operating manual.
• Failure to follow this operating manual will compromise the safety of the appliance.
• When passing the appliance on to third parties, include this operating manual.
• This appliance must not be operated by children or individuals with limited physical, sensory, or mental abilities, as they may
not recognize the hazards associated with the use of electrical appliances, leading to accidents, fires, explosions, or property
damage.
• After unpacking the appliance, ensure that everything is in perfect condition. If you discover any damage, do not connect the
device; instead, contact your dealer.
• Verify the presence of all components specified in the delivery. If not, notify your dealer.
• Retain the packaging of the appliance. Only in the original packaging can the appliance be safely transported, for example, for
repairs or when moving. Note that all packaging components (plastic bags, cardboard, styrofoam parts, etc.) can pose a
danger to children and should not be stored near them.
• If storing the packaging is not possible, separate the various packaging materials and deliver them to the nearest collection
point for proper disposal.
• Do not use the appliance outdoors in rainy conditions or in damp rooms.
• Do not operate the appliance unattended.
• Observe the accident prevention regulations applicable to the operating
environment and the general safety regulations.
• Place the appliance in a dry, well-ventilated area on a flat, secure surface.
• Before connecting to the power grid and before commissioning, clean the appliance thoroughly as indicated under "Cleaning."
• Before connecting the appliance, ensure the presence of a grounded Schuko socket and a 230-volt connection, matching the
information on the nameplate. Using other power sources not specified on the nameplate may lead to overheating or device
malfunction.
• Do not drill or puncture holes in the interior or exterior of the appliance. The circuit could be damaged.
• The manufacturer/dealer cannot be held responsible for damages resulting from non-compliance with the operating
instructions. The safety of the appliance is also no longer guaranteed in such cases.
• In case of a malfunction, disconnect the appliance from the power grid and notify your dealer. They will carry out the repair
with original spare parts.
• Do not store the appliance at low temperatures, as water remains in the boiler.
SAFETY INSTRUCTIONS
• Incorrect operation and improper handling can lead to malfunctions in the device and injuries to the user.
• Observe the accident prevention regulations applicable to the operating environment and the general safety regulations.
• Ensure a secure placement on a dry, sufficiently weight-bearing, non-slip surface corresponding to the device's weight and in a
well-ventilated area.
• Do not expose the device to direct sunlight, do not place it near other heat sources (heater, stove, oven, open flame), and do
not place it on a hot surface.
• Do not store flammable or explosive substances near the device. Avoid working with flammable substances in the vicinity of
the device (no paint or spray cans, etc.), as it could lead to fire or explosion.
• Do not place heavy objects, loads, or liquids on the device.
• Before connecting to your power grid, check if the power type and voltage match the information on the nameplate. Operation
is only possible if they match, to avoid accidents/defects.
• Do not use adapters, power strips, and/or extension cords; overheating of cables/lines can occur quickly if additional devices
are connected, increasing the risk of fire.
• Do not move the device during use. • Before moving the device, turn it off (if a switch is available) and unplug the power cord.
• Always unplug the cable from the socket by pulling on the plug housing.
• Ensure that the device does not tip over when moving. This could result in injuries.
• After a power outage or brief disconnection, turn off the device, wait for 5 minutes, plug in the cord again, and restart the
device.
• Do not let the power cable hang over sharp edges, do not pinch it, and keep it away from hot objects and open flames.
• Ensure that accidental pulling on the cable or tripping over it is not possible.
• Regularly check the cable. If damaged, e.g., by pinching, it must be replaced by a qualified professional.
• Do not touch the device, cable, and plug with wet or damp hands.
• Caution! The device is powered as long as it is connected to the power grid.
• Protect the device from moisture.
• Do not clean the device with an open water jet.
• Do not immerse the device in water or other liquids or wet it with liquids. If the device does get wet, immediately unplug the
power cord and have the device inspected by a professional before using it again. There is a risk of electric shock.
• A damaged device must not be used! In this case, disconnect the device from the power grid and contact your specialist
dealer!
• Never attempt to open or repair the device yourself. There is a risk to life!
• Do not drill or puncture holes in the device, neither from the outside nor in the interior. Do not install other devices or attach
foreign objects there.
• Repairs must be carried out by qualified professionals with original spare parts.
• Before each cleaning, disconnect the device from the power grid, as well as during prolonged non-use.
• For hygienic reasons, daily cleaning is recommended, but also as needed throughout the day.
Stand 02/24 SvN
Seite 16 von 22