Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Releasing the quick clamps
Release the four levers (13) of the camloks by turning them anticlockwise.
• Taking out the effects kit
Slowly lift the effects kit to remove it from the projector head, taking care not to dis-
turb the internal wiring.
Delicately place the Stage Color effects kit on the worktop.
• Removing the spherical reflector cover
Using a 3mm Allen key unscrew the two screws (14) and remove the plate (15) to
uncover the spherical reflector.
Using the screws you have taken out, secure the plate (15) to the Stage Color 1200
effects kit and then put the kit back into its packing. Clean the spherical reflector if
necessary.
14
15
All manuals and user guides at all-guides.com
7
13
8
9
14
15
• Closing the side cover
Hinge the side cover up (9) opened beforehand, and close it again, tightening the
two thumb screws (10).
10
9
• Removing the side cover
Remove the side cover (16) from the projector shoulder, on the same side as the
pan locking lever (2), namely on the side where there is no tilt locking device (1).
Using a Philips screwdriver loosen the screws (17) without removing them com-
pletely.
16
17
2
• Removing the Tilt limiter
Using a 3mm Allen key and an 88mm spanner, remove the limit stop pin (19) of
the Tilt movement from the pulley (18) by completing removing the screw (20).
Carefully arrange the parts you have removed as they need to be reassembled
later.
20
19
10
11
1
12
18
Werbung
