Your Device At A Glance; Operation - Euromate 482316 Originalbetriebsanleitung

GB
• The device may not be operated outdoors.
• The device may never be operated without super-
vision.
• Never put objects through the ventilation grate
into the device. Mortal danger!
• Never subject the device to water or other liquids.
• The device may neither be operated in rooms with
a bathtub, shower or swimming pool nor near
washbasins or water connections.
• The device may not be covered. There is danger
of fire.
• Do not use extension cable or multi-socket. Use
the appliance only on a wall socket.
• Do not use the product in damaged or ill-fitting
plug sockets
• Do not use the heater in conjunction with a timer
or any other switch capable of automatic activa-
tion, as this creates a fire hazard.
• This appliance can be used by children aged from
8 years and above and by persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and if they understand
the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
• Children of less than 3 years should be kept away
unless continuously supervised.
• Children aged from 3 years and less than 8 years
shall only switch on/off the appliance provided
that it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved. Children aged from 3 years and
less than 8 years shall not plug in, regulate and
clean the appliance or perform user maintenance.
• CAUTION! Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and vul-
nerable people are present.
• Do not use this heater in small rooms when they
are occupied by persons not capable of leaving
the room on their own, unless constant supervi-
sion is provided.
• Symbols appearing on your device may not be
removed or covered. Signs on the device that are
no longer legible must be replaced immediately.
Read and observe the instructions for use
before using the product for the first time.
To prevent overheating, do not cover the
heater!
Caution, hot surface! Danger of being burnt!

Your device at a glance

Note: The actual appearance of your prod-
uct may differ from the illustrations.
► P. 3, item 1
1. 700 W Handy Plug-in Heater main unit
20
2. On/Off switch
3. Control panel
4. Increase temperature button [+]
5. Decrease temperature button [−]
6. LED display
7. Power button [ ]
8. Timer button [ ]
9. Plug rotation button
10. Vent
11. Air intake
12. Finger hold

Operation

Check before switching on!
DANGER! Risk of injury! The device must
only be put into operation if no faults are
found during the check-up. If any part of the
device is defective, it must be replaced
before the next use.
Check the safe condition of the device.
– Check whether there are any visible defects.
– Check whether all parts of the device are firmly
attached.
Using the 700 W Handy Plug-in Heater
– Plug in and switch on the plug-in heater at the
mains power supply.
– To turn on the plug-in heater, press the on/off
switch (2) and then press power button.
– Press [+] to increase the temperature output;
press [−] to decrease the temperature output.
– The temperature can be set between 15 °C and
30 °C.
– To increase or decrease the fan speed, press [+]
and [−] at the same time. Press both buttons
together once for a low speed setting, the LED
display will show [LL]. Press both buttons
together again for a high speed setting, the LED
display will show [HH].
– Activate the timer setting by pressing timer button;
the display will change from [°C] to [HOURS].
Press timer button until the desired number of
hours has been selected; 12 hours is the maxi-
mum selection.
• Timer off – If the timer function is set when the
plug-in heater is switched on, the number of
hours is set to when the heater will turn off.
• Timer on – If the timer function is set when the
plug-in heater is switched off or on standby, the
number of hours is set to when the heater will
turn on.
– To switch off the plug-in heater, press power but-
ton. The fan will cool for approx. 60 seconds
before switching off. Press the on/off switch and
wait for the plug-in heater to cool fully before
unplugging.
Note: The plug-in heater will only produce
heat if the set temperature is higher than the
room temperature.
WARNING! Risk of injury! Never leave the
plug-in heater connected to the mains
power supply whilst not in use.