F&P Eson 2 Bedienungsanleitung Seite 4

2 ENGLISH
ii
FITTING YOUR MASK
1. Remove all packaging before using your mask.
2. Hold open the bottom straps of the Headgear
Mask Frame
3. Guide the headgear
seal is resting on your forehead.
4. Place your hands on the bottom straps on either side of the
mask frame
silicone seal
sitting on your forehead.
5. Gently tighten the headgear straps of the mask headgear
starting with the blue forehead straps followed by the
bottom straps.
6. The forehead straps should rest horizontally on the forehead,
just above the ears. If required the crown strap can be
adjusted to achieve this.
Useful fitting tips:
• If you are experiencing mask leaks, you may need to lift the
Silicone Seal
• Ensure the mask's headgear straps are not fastened too
tightly.
• The forehead straps should rest horizontally on the
forehead, just above the ears.
iii
DISASSEMBLY FOR CLEANING
1. Unhook the Headgear Clips
2. Slide the forehead straps of the Headgear
from the top of the Mask Frame
3. Remove the Silicone Seal
4. Remove the Swivel
5. Remove the Diffuser
facing downwards.
over your head so that the silicone
and pull out and downwards. Ensure the
rests over your nose and the blue top strap is
off your face and reposition it again.
from the Mask Frame
from the Elbow
from the Elbow
from the Mask Frame
.
.
.
with the
.
downwards
.