Installation On A Wall Mounting - Omnitronic PAS PRO Bedienungsanleitung

Before taking into operation for the first time, the installation has to be approved by an expert!

Installation on a wall mounting

Procedure:
Step 1: On the wall mounting, there are the holes for the installation.
Step 2: Hold the wall mounting onto the location where it is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the wall mounting in the desired position and tighten the screws.
Step 6: Insert the eye bolts into the threaded holes. The eye bolts must be tightened until stop position,
hand-tight and without any tools.
Step 7: Install the speaker system on the wall mounting.
Step 8: Insert the quick links of the safety bonds in the eye bolts of the speaker system. Pull the safety
bonds through the wall mounting's safety eyelet. Insert the end in the quick link and tighten the
safety screw.
The wall mounting's maximum service life must never be exceeded.
DANGER TO LIFE!
When installed on a wall mounting, the speaker system must always be
secured with a safety bond.
Before attaching the speaker system, make sure that the installation area
can hold a minimum point load of 10 times the installation's weight (e.g.
13 kg weight - 130 kg point load).
The durability of the installation depends very much on the material used
at the installation area (building material) such as wood, concrete, gas
concrete, brick etc. This is why the fixing material must be chosen to suit
the wall material. Always ask a specialist for the correct plug/screw
combination indicating the maximum load and the building material.
The wall mounting must always be installed via all fixation holes. Do only
use appropriate screws and make sure that the screws are properly
connected with the ground.
22/28
Please note: Before installing the eye bolts,
make sure that the thread is always in perfect
condition and free from dirt etc.
Install the eye bolts in the threaded holes of the
speaker system. The eye bolts must be
tightened until stop position, hand-tight and
without any tools.
Insert the quick links of the safety bonds in the
eye bolts of the speaker system. Pull the safety
bonds over a safe fixation spot. Insert the end in
the quick link and tighten the safety screw.
The maximum drop distance must never exceed
20 cm.
A safety rope which already hold the strain of a
crash or which is defective must not be used
again.
00063757.DOC, Version 1.0