Now You Can Set Off On Your Travels; Cautions When Operating The Rc Model; Load Platform; Rope Winch - Carson Mercedes Benz Unimog U300 Betriebsanleitung

NOW YOU CAN SET OFF ON YOUR TRAVELS

1
Avoid continuous running. Allow the motor to cool down approxi-
mately 30 minutes after running.
Attention!
Switch on transmitter first, then switch on RC model. Make sure to
follow this order when turning on your RC model.

CAUTIONS WHEN OPERATING THE RC MODEL

3

LOAD PLATFORM

Right
control lever
GB // 18
The load platform can be controlled
using the transmitter:
To tip the load platform, push the
right control lever up.
After unloading, push the lever back
down. The load platform will return to
its original position.
2
Never run the model on public roads or streets, as it could endan-
ger traffic.
• Never run the model in crowded areas, near or toward people
or animals, to prevent property damage and/or personal injury.
• Never run the model on grassland. Twining grass may hinder
axle rotation and may cause motor heat buildup.
• Never run the model near rivers, ponds or lakes as to prevent
RC model from dropping into the water.

ROPE WINCH

First activate the rope winding func-
tion on the underside of the chassis.
Then push the left control lever to the
right to unwind the rope.
The control lever must then be
pushed to the left to wind the rope
Left back in again.
control lever