AEG HK634060XB Benutzerinformation Seite 20

6.2 Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, sugar and food with sugar,
otherwise, the dirt can cause damage to
the hob. Take care to avoid burns. Use a
special hob scraper on the glass surface
at an acute angle and move the blade on
the surface.
• Remove when the hob is sufficiently
cool: limescale rings, water rings, fat
7. TROUBLESHOOTING
7.1 What to do if...
If you cannot find a solution to the problem below, check the full version of user
manual online or contact an Authorised Service Centre, if necessary.
Problem
You cannot activate or operate
the hob.
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds when
the hob is deactivated.
Automatic Heat Up does not op‐
erate.
You cannot activate the outer
ring.
The sensor fields become hot.
20 ENGLISH
• Remove shiny metallic discoloration:
Possible cause
The hob is not connected to an elec‐
trical supply or it is connected incor‐
rectly.
The fuse is blown.
You do not set the heat setting for
10 seconds.
You touched 2 or more sensor fields
at the same time.
There is water or fat stains on the
control panel.
You put something on one or more
sensor fields.
The zone is hot.
The highest heat setting is set.
You decreased the heat setting to 0.
The cookware is too large or you put
it too near to the controls.
stains, shiny metallic discoloration. Clean
the hob with a moist cloth and a non-
abrasive detergent. After cleaning, wipe
the hob dry with a soft cloth.
use a solution of water with vinegar and
clean the glass surface with a cloth.
Remedy
Check if the hob is correctly connected
to the electrical supply.
Make sure that the fuse is the cause of
the malfunction. If the fuse is blown
again and again, contact a qualified
electrician.
Activate the hob again and set the
heat setting in less than 10 seconds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the sensor
fields.
Let the zone become sufficiently cool.
The highest heat setting has the same
power as the function.
Start from 0 and increase the heat set‐
ting.
First, activate the inner ring by chang‐
ing the heat setting.
Put large cookware on the rear zones,
if possible.