Forch 5331 2 1 Bedienungsanleitung Seite 30

DO NO allow the Electric Agitator to run empty.
■
Do not remove any mixed material while the unit is running! Do not reach into
■
the mixing drum!
DO NOT start the machine when the dried materials are in the drum or stick to the drum!
■
The unit will only function properly if it is operated carefully!
■
Please wear protective googles and ear protection when operating the machine!
■
DO use only original spare parts for the machine maintenance!
■
8. Maintance
Correct maintenance for the machine can prolong the working life; The handle switch must
always be kept in proper function and good maintenance.
The mixing tools should be cleaned when the work is finished or you are planning not to use
the Electric Agitator for a longer period of time. Normally the flowing water or quarz sand
can clean the mixing tools well. Do not expose the device to mechanical stresses, loads or
weights. This will inevitably damage it.
The mixing rod should always be clean.
The hexagonal key opening should always be covered with a protection.
Do not cover the vent hole in the motor housing while the unit is in operation.
Do not add flammable materials to the machine.
Clean the vent opening frequently. Use only original spare parts on this machine.
Check and service the carbon brush after 60 hours of operation. Replace it in good time if it
is worn. Refer to the illustrations for details of operation.
Picture 1
Picture 1: Cut off the power first, take apart the motor housing.
Picture 2: Pull out the plate and replace the carbon brush.
Picture 2