Wolkenstein SL I4-90 A++ IXTZ W Bedienungsanleitung Seite 42

OPEN
1
➢ Turn to the left = Remove a previously installed carbon filter.
CLOSE
➢ Turn to the right = Place the carbon filter on the motor and
2
turn the filter to the left slightly or jerk it carefully until the filter
is installed properly.
1. Remove the
ALUMINIUM GREASE FILTER
2. The
CARBON FILTERS
3. Match the brackets of the filter with the holding mechanism of the motor and
jerk carefully until the filter locks.
F
ILTER BRACKETS
4. Repeat the procedure on the other side of the motor.
5. Reinstall the
ALUMINIUM GREASE FILTER
6. If you want to uninstall the
remove them.
WARNING! Install the carbon filters safely and properly; otherwise the
carbon filters can loosen and cause hazardous situations.
NOTICE! The suction capacity is decreased by installed carbon filters.
NOTICE! Depending on frequency of use, replace the carbon filters every
three to six months. Clean the grease filter(s) regularly for proper operation
of the motor (s chapter C
:
:
are intended to be installed on both sides of the motor.
CARBON FILTERS
LEANING AND MAINTENANCE
( ).
S
H
OLDING MECHANISM
( ).
S
, turn the filters anti-clockwise and
).
/
MOTOR
42