Werbung
ENGLISH
@ > DIRECT
Set the switches to the DIRECT positions when the pre-amplifier output is connected to the DIRECT terminals. In this case the
input level is adjusted with the Left and Right INPUT LEVEL controls.
e
Notes on Speaker Connections
e
Observe the correct polarity of the terminals: connect (—) leads to (—) terminals and (+) leads to (+) terminals. If the
polarity is incorrect the sound image will be distorted, with the positions of musical instruments being unclear and
impaired stereo imaging.
@
When connecting the speaker cords, be sure the strands of the center wire do not protrude and contact other terminals or
other bared speaker leads.
e Speaker Impedance
e
Ifthe A and B speaker systems are not to be used simultaneously, the speakers that are to be connected should have a
nominal
impedance
of 4 to 16 ohms.
e
|ftwo speaker pairs (A + B) will be driven simultaneously, use of speakers whose impedance rating is outside the range
of 8 to 16 ohm
will result in malfunction. Thus, be sure the speaker impedance
is correct.
e
For regular speaker cords
1. Remove
the insulation from
Note:
the end of each cord.
Each speaker terminal
is fitted
2. Twist the center wire.
with a knob that separates from
3. Turn
the
speaker
terminal
the terminal.
Be careful
not to
counter-clockwise to open
it,
lose these knobs and always be
insert the twisted center wire
sure
the
correct
polarity
is
into the terminal
hole, and
observed
when
connecting
turn the terminal clockwise to
them.
Follow the directions on
hold the wire in place.
the rear panel.
e For extra-large cords
1. Remove
the insulation from
the end of each cord.
2. Loosen and remove the end
of the speaker terminal.
3. Insert the center wire through
this piece and fold back the
speaker wire.
4. Reinsert
the piece
into the
terminal and turn clockwise to
tighten it.
Werbung
