Werbung
@
PROTECTOR (Protection Button)
e
The amplifier
incorporates
a speaker
impedance
protection circuit. If this circuit is triggered, it can be
released by pressing this button.
e
The speakers-A or speakers-B
indicator may flash
when using speakers with extremely low impedance
ratings.
If this happens,
adjust the volume
level until the
indicators stop flashing and to obtain better sound
quality.
SPECIFICATIONS
Rated output power:
Dynamic
power:
Total harmonic
distortion:
Intermodulation
distortion:
Power band width:
Frequency response:
200 W + 200 W min., RMS into 8 ohms
from 20 Hz to 20 kHz with no more
than 0.01% total harmonic distortion
330 W + 330 W (4 ohms, DIN 1 kHz)
450 W + 450 W (at 4 ohms)
620 W + 620 W (at 2 ohms)
750 W + 750 W (at 1 ohm)
Less than 0.002%
(-3 dB at rated output, 8 ohms)
Less than 0.002%
(60 H2/7 kHz: 4/1 at rated output
8 ohms)
5 Hz—80 kHz
(8 ohms, THD 0.03%)
1 Hz-300 kHz +0, —3 dB
(at 1 W) (DIRECT)
1 Hz-— 100 kHz +0, -3 dB
(at 1 W) (NORMAL)
ENGLISH
1 0) INPUT LEVEL (Left Channel Input Level Control)
Use this control to adjust the input level of the left
channel.
@
INPUT LEVEL (Right Channel
Input Level Control)
Use this control to adjust the input level of the right
channel.
Input sensitivity:
Input impedance:
Output impedance:
S/N ratio:
Output terminals:
Power supply:
Power consumption:
Dimensions:
Weight:
1 V (NORMAL/DIRECT)
25 k ohms
(NORMAL)
25 k ohms (DIRECT)
0.1 ohm (1 kHz)
123 dB (IHF, A-weighting)
Speakers
A oor B 4-16 ohms
A+
B
8-16 ohms
AC 220 V/50 Hz
(for European countries)
AC 240 V/50 Hz
(for U.K. and Australia)
500 W (for IEC)
434 (W) x 187 (H) x 429 (D) mm
(Including control knobs and feet)
17.5 kg
* Design and specifications are subject to change without prior notice.
Werbung
