Herunterladen Diese Seite drucken

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Pic. 1
F
E
1
1
5
1
0
0
D
/D
Mod+
Mod–
230 V
AC
Switch for
the RS-485
end resistor
S0-
S0+
Pic. 2
Mounting instruction | 431951740A | 2015-08-03
Pic. 3
E
E
1
1
1
1
0
0
Modbus over RS-485
serial line
max. 1200 m
GND (common)
R
R R R
28
35
Address high
3
6
0
9
6
3
0
9
Address low
Adresse 51
Pic. 4
43
58

Werbung

loading

Inhaltszusammenfassung für Honeywell EEM-CONVERT S0-Puls

  • Seite 1 Pic. 3 Pic. 1 Modbus over RS-485 serial line Mod+ Mod– max. 1200 m 230 V Switch for the RS-485 end resistor GND (common) R R R Address high Address low Adresse 51 Pic. 2 Pic. 4 Mounting instruction | 431951740A | 2015-08-03...
  • Seite 2 Deutsch Montage- und Bedienungsanleitung EEM-CONVERT EEM-CONVERT S0-Puls Zähler mit Modbus Schnittstelle, Pic. 1 Beschreibung Wichtige Hinweise Das S0–Modbus Kopplermodul ist ein Gerät zur Erfassung Sicherheitshinweise Nennspannung beachten, bevor das Gerät in Betrieb von S0-Pulsen. Mit diesem Modul können Verbrauchsda- genommen wird (siehe Typenschild). Überzeugen Sie sich, ten jeglicher Messgeräte mit einem S0-Ausgang busfähig...
  • Seite 3 Deutsch Technische Daten Modbus Bus System Modbus, RTU gemäss IDA Spezifikation Übertragungsraten 2400-4800-9600-19'200-38'400-57'600-115'200. Die Übertragungsrate und Parität werden automatisch erkannt Übertragungsmodus Gerade Parität: 8 Datenbits, 1 Stopbit Ungerade Parität: 8 Datenbits, 1 Stopbit Keine Parität: 8 Datenbits, 2 Stopbits Übertragungsmodus wird automatisch erkannt. Bus Länge (max.) 1200 m (ohne Repeater) Reaktionszeit:...
  • Seite 4 Register For double registers (4–5, 16–17, 28–29, 30–31, 32–33, 34–35) the high register is sent first (big_Endian). Counters (28–29, 30–31, 32–33, 34–35) can be reset by writing 0 in both registers. Read Write Description Value / Unit FW-Version Ex: «10» = FW 1.0 Number of supported registers will give «43»...
  • Seite 5 English Assembly and operating instructions EEM-CONVERT EEM-CONVERT, S0 pulse counter with Modbus interface, Pic. 1 Description Important instructions The S0-Modbus coupler module is a device for the collec- Safety tion of S0 pulses. With this module the consumption data Check compliance with nominal voltage before commis- of any measurement device with a S0 output becomes bus sioning the device (see type label).
  • Seite 6 LEDs are flashing each with 1 Hz, however the S0 pulses are counted Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sàrl, Rolle, Z.A. La Pièce 16, Switzerland by its Authorized Representative:...
  • Seite 8 Italiano Istruzioni d’uso e montaggio EEM-CONVERT EEM-CONVERT, contatore d’impulsi S0 con Modbus, Pic. 1 Descrizione Istruzioni importanti Il modulo S0-Modbus è un apparecchio per la raccolta di im- Sicurezza pulsi S0. Con questo modulo i dati di consumo di qualsiasi Prima della messa in esercizio del dispositivo, verificare la contatore con uscita S0 diventano accessibili tramite Mod- conformità...
  • Seite 9 Italiano Dati tecnici Modbus Sistema Bus Modbus, RTU conforme alla specifica IDA Velocità di trasmissione 2400-4800-9600-19'200-38'400-57'600-115'200. La velocità di trasmissione e la parità viene riconosciuta automaticamente Modalità di trasmissione Parità pari: 8 bit di dati, 1 bit di stop Parità dispari: 8 bit di dati, 1 bit di stop Nessuna parità: 8 bit di dati, 2 bit di stop Modalità...
  • Seite 11 Francais Instructions de montage et d’exploitation EEM-CONVERT EEM-CONVERT, compteur d’impulsions S0 avec interface Modbus, Pic. 1 Description Consignes importantes Le module S0-Modbus est un dispositif pour la récolte Sécurité Vérifier la tension nominale avant de mettre l’appareil en d’impulsions S0. Avec ce module, les données de con- service (cf.
  • Seite 12 LEDs clignotent à 1 Hz. Toutefois, la comptabilisation des impulsions S0 reste valide. Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sàrl, Rolle, Z.A. La Pièce 16, Switzerland by its Authorized Representative:...