Carson Expert Charger All Rounder 2A Betriebsanleitung Seite 8

CHARGING PROCEDURE
Charging current: 0.7 A / 2 A
Set the charging current: Hold the "LiPo" button for at least 2 seconds.
• Green and yellow LED/ 0.7 A charging current
• Green, yellow and red LED/ 2 A charging current
• Press any button to exit the setting.
Note: Check the charging current before charging. The default charging current is 2 A.
Charging instructions:
Important!
• Do not simultaneously connect 2s and 3s batteries to the balance port or connect different types of batteries to the charger.
• Do not change the battery type during the charging process.
1. Connect the charger to the mains.
2. The green light on the charger will switch on and confirm the function.
3. To change the charging current to 0.7 A, follow the steps above.
4. There are three buttons for changing the battery type (green light: Li-Po, yellow light: Li-Fe, red light: Ni-MH). Press the required button
and the corresponding LED will switch on to confirm the setting.
5. Connect the battery to the corresponding battery input. When using a NiMH battery, use the supplied Y-cable to connect it to the
charger.
6. Briefly press the corresponding button to start the charging process. The LED will start to flash.
7. The charging process is complete when the LED stops flashing and stays constant.
8. The charging process can be interrupted by pressing the corresponding button. The LED will then stay constant.
Troubleshooting:
• All 3 LEDs are flashing at the same speed. This indicates that the
battery may be defective or that an error may have occurred.
Remove the battery and reconnect it to the charger.
• If the issue persists (LEDs keep flashing), replace the battery.
GB // 8