Werbung
Verfügbare Sprachen
Verfügbare Sprachen
en
Children should not use the appliance.
Children should be supervised to ensure
that they do not play with the pressure
washer.
This appliance can be used by persons
with reduced physical, sensory or men-
tal capabilities, or lack of experience and
knowledge if they have been given super-
vision or instruction concerning use of the
appliance in a safe way and understand
the hazards involved.
– WARNING: The pressure washer must
be unplugged from the power supply
when cleaning or servicing, or when
replacing parts - unplug from the wall
outlet. Do not use the appliance if the
power cord or important parts of the
appliance, such as safety devices, high
pressure hoses, trigger, are damaged.
– WARNING: Extension cords that do not
match the power cable can be danger-
ous. Use extension cords that are suit-
able for the power supply (the longer
the extension cord, the larger the wire
cross-section: up to 25 m - 1.5 mm
cross-section, over 25 m - 2.5 mm
cross-section).
Notes on connecting to a power
source
The voltage of the power supply must
correspond to the data on the pressure
washer nameplate.
Always unplug the appliance, even if you
leave it unattended for a short time.
In case of damage to the power cable,
to avoid danger, contact the manufactur-
er (DNIPRO M LLC), the DNIPRO-M autho-
rized service center, or the seller of the
product.
Never handle the power plug with wet
hands.
Do not run over, squeeze, or jerk the pow-
er cord or extension cable, as it may be
damaged. Protect the power cord from
heat, oil, and sharp edges.
Notes on connecting to a water
source
All connecting hoses must be tightly
screwed.
Use a 12.7 mm (1/2 in.) diameter rein-
forced water hose or other hose of the
8
required length with the required fitting
(adapter).
Only connect the pressure washer to a
potable water supply with a backflow
preventer. Water that flows out of the
backflow preventer is not considered po-
table water.
The high-pressure hose must not be dam-
aged (danger of rupture). If damaged, the
high pressure hose must be replaced. Use
the accessories recommended by the
manufacturer.
Operating instructions
Before use, check the pressure washer
and components for damage to ensure
safe use.
The pressure washer must be supported
on a solid surface.
Objects can bounce back under high
pressure. Wear safety glasses if neces-
sary.
Some detergents and chemicals can be
harmful if inhaled. Use a mask when there
is a risk of vapor poisoning.
2
To avoid damaging the paintwork with
2
the high-pressure jet, only wash vehicles
from a distance of at least 30 cm.
Do not use the pressure washer near com-
bustible materials or flammable gases.
Do not spray materials containing asbes-
tos or other materials containing sub-
stances harmful to health.
Using the pressure washer with a dam-
aged or missing filter is prohibited. Us-
ing the pressure washer without a filter or
with a dirty or damaged filter will void the
warranty.
Use the pressure washer only for its in-
tended purpose.
Never leave the appliance unattended
when it is turned on.
The water jet coming out of the nozzle
creates a kickback. For this reason, the
spray gun and the extension nozzle must
be held with both hands.
Before disconnecting the high-pressure
hose, relieve the overpressure by press-
ing the button on the gun.
These original safety and operating in-
structions cannot cover all cases that
may arise in the actual use of the appli-
EU-PW0923001-0923001
Werbung
