Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Make sure that moisture does not en-
ter the openings on the appliance hous-
ing. If the ventilation openings are heavily
soiled, blow them out with compressed
air.
Clean the nozzles and spray nozzles reg-
ularly (Fig. 35).
Clean any dirt from the nozzle opening
of the nozzles and attachments with the
needle (included) (Fig. 35).
After every two hours of operation, rinse
the coarse filter with clean running wa-
ter (Fig. 36). To do this, unscrew the filter
housing (1), remove the filter (2) and rinse
it. Also rinse the detergent tank filter with
clean running water (Fig. 37).
9. SERVICE
Always keep the ventilation openings
clean. Periodically, at least once a month,
check the appliance for damage, even if it
has not been used.
Unless otherwise expressly provided for
in this manual, the product must be ser-
viced only by the manufacturer (DNIPRO
M LLC), the DNIPRO-M authorized service
center, or the seller of the product.
WARNING!
If the power cord is damaged, it
must be replaced by a service cen-
ter to avoid a hazard.
10.
STORAGE AND
TRANSPORTATION
In order to avoid damaging the pressure
washer when exposed to temperatures, it
is necessary to:
– Remove the water completely. Turn on
the appliance without the water supply
(for a maximum of 30 seconds) and wait
until the water stops flowing.
– Store the high-pressure device with all
components at a temperature not low-
er than 0 °C and not higher than +50 °C.
EU-PW0923001-0923001
Use the original packaging for storage
and transportation.
Do not transport the pressure washer as-
sembled.
Keep the appliance, the original safety
and operating instructions, and the ac-
cessories in their original packaging. This
way, you will always have all the neces-
sary information and parts at hand.
The pressure washer can be transport-
ed by all means of transport that ensure
its safety in accordance with the gener-
al rules of transportation. During loading
and unloading and transportation, the de-
vice must not be subjected to impacts.
Placement and fastening of the device
in vehicles must ensure a stable position
and the absence of the possibility of mov-
ing the device during transportation.
11. DISPOSAL
Do not dispose of the appliance
with household waste!
The
decommissioned
washer must be stored and dis-
posed of separately in accordance
with environmental legislation.
en
pressure
19
Werbung
