DeVilbiss Healthcare drive Multitec Gebrauchsanweisung Seite 17

Mounting the armrests
Mounting the leg supports
Mount the leg supports on the brackets on the front pro-
vided for this purpose on the wheelchair (pic. 7). Turn the
leg supports inward. Ensure that the leg supports are se-
curely in position (pic. 8).
Foot plates
After you have inserted the leg supports, rotate the foot
plates downward (pic. 9). The supporting surface of the
foot plates is telescopic (pic. 10).
Mounting the headrest
Insert the headrest into the provided bracket on the
backrest. To do this, pull the locking knob (pic. 11) out and
push the headrest all the way down. Let go of the locking
knob and pull the headrest up until it snaps into the first
Drive Medical GmbH & Co. KG | As per: 24.04.2020 | Errors and alterations excepted
Press the locking knob
and push the side parts/
armrests into the brackets
provided for this purpose
until they click into place.
position. Now, by pulling the locking pin outwards again
and simultaneously pulling upwards, you can change the
height of the headrest. Make sure that the locking knob
snaps into the selected position (pic.. 12).
Push handle
The push handle can easily be adjusted to the require-
ments of the attendant.
Loosen the T-screws on both sides of the push handle
(pic. 13-14) and bring the push handle into the desired
position.
Take care that the T-screws are securely tightened again.
Height of the armrest
The height of the armrests can be adjusted for comfort-
able and fatigue-free sitting.
To change the height of the armrests, press the locking
knob and pull the armrest upwards. (pic. 15).
The armrest can be locked in 3 positions. In addition, the
armrest holder can be secured at 3 heights. (A)
A
EN
17
Instructions for use MULTITEC