JK-Products ERGOLINE ESSENCE Serie Montageanweisung Seite 63

Assembly
5 Assembly
11/2012
This section describes the steps for the assembly in detail.
DANGER!
Electricity throughout entire device!
Installation and electrical connections must comply with the
national regulations, in Germany VDE regulations.
The electrical installation is to be fitted with an easily accessible
all pole isolating device (master switch) on the building side,
complying with overvoltage category III. This means that each
pin shall have a contact opening width complying with the con-
ditions of overvoltage category III for full isolation.
If the connection is carried out using a plug connection, a plug
system should be used that corresponds with the current
EN 60309 version.
Assembly, installation, upgrading or repair of the device may
only be carried out by specially trained and instructed person-
nel.
5.1 Position plate and fit column
– Place protective film on the floor.
– Place the cardboard on the floor.
– Position the column (2/4) on the cardboard with the rear side facing
downwards so that the front part does not touch the floor.
– Remove the screws.
Installation: Devices with Vibra Shape
– If Vibra Shape should be installed, the height of the feet must be adjusted
now (see service information 1012358-..).
Installation instructions 19/40