Troubleshooting - Rovary Rv2000P Bedienungsanleitung

Troubleshooting

Problem
The CO2 monitor displays
an E1 error
What to do in case of a red
light, but a good
PPM value?
14
Solution
It is possible that an E1 error appears on the screen of the CO2
monitor. In this case, a sensor has become detached and the
monitor is no longer functioning properly. The advice is to contact
Rovary customer service by emailing to support@rovary.com.
It is possible that the light of the CO2 monitor lights up red, while
the PPM value is correctly displayed. This can occur for the
following 3 reasons:
1. The monitor is set to plant mode, the advice is to set the monitor
back to human mode. See page 8 for instructions.
2. The parameters are set incorrectly. See page 10 for instructions.
3. The monitor needs to be reset. This can be performed by
holding the ENTER button for 5 seconds. This will reset the
unit to factory settings.